Different shaped kiln lime kiln has a different preheating, calcining, cooling and discharging mode. But there are a few principles are the same processes namely: high quality raw materials, lime and good quality; fuel of high calorific value, quantity consumed less; limestone calcination time is proportional to the size and; quicklime degree of activity and calcination time is inversely proportional to the calcination temperature. Lime kiln in operation in accordance with procedures to be carried out, should pay special attention: to clean up after the cessation of drying kiln drying kiln incineration of waste generated in order to prevent obstruction material after landing. Incineration is most crucial point was lit average, average Gabe material, the material time to time based on raw material particle size and a good grasp of quantity. Applications should be appropriate to send the wind, the initial strict control of air flow, then every time a proper progress by wind. Kiln temperature was promoted to slow speed, generally 20 --- the 30th place to swap. Staff must be careful to run the job together, so to see the fire Qin Qin Qin unloading materials, multi-fabric or continuous feed to the right, mixing to average ratio to be stable, with the wind should be appropriate. Kiln every period should overhaul once, stop the kiln after many maintenance work to be done. Ensure the fastest repair time and then resume production. During a major overhaul to stop the kiln Rotary Kiln deformation, rotary kiln off the brick lining whether phenomena such as heat-resistant material loss is serious. Kiln roller bearing lubricant to regularly add, kiln hood should be cleaned regularly and so on. The above article by Henan YuFeng Heavy Machinery (http://www.yufchina.com) finishing release, reproduced, please indicate the source!