In normal production, must be maintained rotary kiln "straight and round" geometry. However, due to violation of rules, such as when you are not required to stop

the kiln rotary kiln, or local brick shed not timely fillings, or special causes to stop the kiln after long drive (such as seals burned, a sudden power outage, cone

damage, etc.) tube bends experience, serious, belt and roller wheel disengagement, and even turn no kiln phenomenon. If this happens, use the auxiliary motor

turning kiln LP, until the resumption of large motor can turn the kiln. In slow rotary kiln when burning low heat, slowly turn the kiln shell after gradually returning to

normal, then the force roller adjusted properly. If after bending kiln, rotary kiln auxiliary motor can only turn half circle, put the kiln body curved arch to the top, and

then stop the kiln fire ended, so that the kiln cooling, the curved arch will slowly return to normal, then the ignition switch kilns. After kiln line from the kiln motor

ammeter to see the current instability, prone to fall brick kiln, roller wheel in contact with the uneven, causing severe tire shift phenomenon. Please indicate Henan

YuFeng Heavy Machinery