Normal07.8 pounds 02MicrosoftInternetExplorer4 we can plant lane lifting weights, then calculate the weight of the various components of ball mill, tube and both ends of the lid portion of the line weight lifting cranes within the cylinder and the ball ends can be assembled after the lid portion Approach installation (cylinder liner is not installed, the end cap ball mill liner installation).This installation method can speed up the progress of construction, shorten the construction period. Before the formal installation Ball Mill, to thoroughly clean bush, unless carefully wash the surface of the oil and dust outside, but also carefully cleaned with compressed air blowing bush at the bottom of the hole.No. 200 in the bearing surface of the painting extreme pressure gear oil, saddle and tile back to be painted on the 2nd synthetic extreme pressure lithium grease rust.Then officially hanging on the cylinder for installation. Measuring two trunnion relative elevation, requiring two buses on the top trunnion relative elevation difference no greater than 0.25mm, its methods can be used precision water level measurements, indium-foot steel tower in the ears stand straight shaft to the bearing by hand pressure pump oil, an artificial plate moving cylinder, measured once every 900 to both ends of the four times the number averaged measured comparing the relative elevation difference if the value exceeds requirements, the main floor and in the mill's main bearing seat added between thin steel pad adjustment, opening gasket can be divided into paragraphs cut stepped interfaces, not allowed to use galvanized iron and copper and aluminum and other soft metals production shims. After adjusting the relative elevation trunnion ends after the bearing to measure lateral clearance.Backlash usable length of 250mm feeler, each pad measuring 4:00, the end gap with a feeler also checks each pad also measured 4:00.The sum of both sides of the side clearance of 1.5/1000 journal diameter is preferably 2/1000. The ball mill using hydrostatic bearing, the upper cast Hongdan in the journal, the cylinder on the crane hook to fasten the rope to hang on, to use the road turning, lifting cylinder to be checked after the journal and bearing contact area and contact pattern, retest whether the specification.Stopper 34mm long with two large bundles ends of the cylinder, the cylinder in place with a 100t travel lift, gently situated on the main bearings, lifting as follows: "Ball Mill and cover installation methods" tube mill body structure, cylinder and end caps join type