Ball Mill at work occur when plasma leakage phenomenon is very common, so users do not panic, Henan Yufeng person to teach you a few various ways to deal with this phenomenon.Resulting in the ball mill is mainly due to the pulp slurry leakage into the hollow shaft into the cylinder and the gap, destroyed the original contact surface of the hollow shaft resulting slurry leakage.The leakage of plasma will produce great harm will result ball hollow shaft and bearing damage, there are significant security risks.So we can differ according to the degree of plasma leakage and make the appropriate treatment.The following persons are Yufeng several ways for everyone to say, I hope you will understand after their help.Usually we encountered this phenomenon can think of is to welding, and this method is generally applicable to ball hollow shaft flange corrosion damage relatively light into pulp much, furthermore into the barrel and the hollow shaft with it has not been destroyed, we can use welding method.Of course, this method also has some shortcomings, barrel and hollow shaft relatively poor weldability, coupled with structural force, welding a little difficult, and will appear at the welding cracks, which look into the reliability comparison small.Yufeng person that both methods give us, one of which is sticky, glue in a ball mill using a metal feed port and the hollow axis of applied layer of plastic, after a period of time automatically curing adhesive, so that the inlet and the hollow shaft. contact surface is no gap, which reached the pulp mill leak repair results.Finally the user can use it to seal a magnetic ball mill, the material is installed at the entrance a few magnets, magnetic adsorption by slag and magnetic group is growing, will be filled with ball cavity sealing effect.The drawback of this method is the need and a good seal, only adapted to the magnetic mineral glue.Of course, in order to put an end to the phenomenon of ball mill slurry leakage should please note that the daily maintenance of the equipment maintenance friends.If you need this device, there will be someone to pick up the call for your service!