Kiln Network: clinker calcination, mainly rely on the raw material is heated flame Raw material is heated after a series of physical and chemical changes in the clinker burning, thus greatly affected the flame temperature, the length of the flame, the flame shape and. flame position for clinker, the flame is also good to see the fire control work operations One of the main tasks. (1) normal flame shape strong and lively flame shape, the shape of a full brush head, or like being willow-shaped, the highest temperature region is the thickest part of the flame, not scattered, not sweep kiln skin, smooth and complete than the flame stable, non-violent shock to the kiln skin, nor be held down when the material roll. Because coal injection tube deformation or worn leaking, so pulverized coal into coke deposited on the nozzle, the impact of pulverized coal injection, or phoenix wings are worn to make wind coal mixed uneven children some unusual shape of the flame. (2) the position of the flame in the Jaw Crusherflame vertical position is not in the center line of the material layer should be slightly biased, but should not sweep "kiln skin" and not roll material when pressed, so that the heat transfer beneficial. Should be adjusted to a suitable position according to the situation of the kiln. (3) measures due to incomplete combustion of coal added with the wind too much or too little, or too coarse pulverized coal and other reasons, often resulting in severe chemical incomplete combustion, reduce heat, raw material coming into the firing zone easily, forced to play a small climbing kiln, this time to take active measures to reduce coal generally should be timely, adding a secondary air volume, improved speed, wind coal mixed strengthen and improve the air temperature to burn completely.