As long as a good grasp of the relationship between good Rotary Kiln fuel, feed, air flow, allowing the system to achieve reasonable thermal equilibrium, even very large Rotary kiln in an hour can be added to the optimum yield. Low volume of feed in order to avoid fluctuations in the Rotary kiln conditions are higher than normal amount of fuel demand, so the system easier to overheat, skinning or even blocked. Preheater Rotary kiln prone to clogging low yield, the reason why.In the low volume of feed, due to the small absorber system, balanced development of the high temperature and easy directions.Especially when the product material when the system was suspended in the hot gas stream and the fuel material balance was less than the amount of material to overheat, the easy-adhesion material in the preheater tube, etc. or crust formation. Rotary kiln should yield an optimum value, it is easy to burn with sexual material, bypassing the amount of combustion quality changes, etc., should be explored in operation OK.Rotary kiln early in the Rotary kiln feed should gradually increase the volume of feed, but should avoid prolonged low volume of feed phase.
Rotary Kiln